INVERTER SIO Driver
GP-Pro EX Device/PLC Connection Manual
14
External Device Settings
To configure communication settings, use the FUNC/DATA, Up, Down, or PRG/RESET key on the touch panel
located on the front of the External Device. Refer to your External Device manual for details.
1 Turn ON the power of the External Device.
2 Press the PRG/RESET key to move to the program mode.
3 Press the Up or Down key to display the function code [o00].
4 Press the FUNC/DATA key.
5 Press the Up or Down key to display the setting value.
6 Press the FUNC/DATA key.
7 Press the Up or Down key to display the function code you want to set.
8 Press the Up or Down key to display the setting value.
9 Press the FUNC/DATA key.
10 Press the PRG/RESET key to move to the normal mode.
11 Reboot the External Device.
This completes the External Device settings.
Function Code Setting Setup Description
o00 1
Option select (RS-485
Communications)
Function Code Setting Setup Description
o01 1 Station address
o04 1 Speed
o05 0 Data length selection
o06 0 Parity bit selection
o07 0 Stop bit selection
To Next Page
Loading...
