Fuji Electric FRENIC-Ace series

最終
High Performance Inverter
FRENIC-
Ace
Global model
User’s Manual
24A7-E-0043e
Thank you for purchasing our multifunction FRENIC-Ace series of inverters.
• Be sure to set the destination on inverter type FRN****E2S/E2E-2G/4G/7G for the initial
power supply. Without setting the destination, the inverter cannot be operated. For details, refer to
4.4 Destination setting.
• This product is designed to drive a three-phase motor under variable speed control. Read through
this user's manual and become familiar with the handling procedure for correct use.
• Improper handling might result in incorrect operation, a short life, or even a failure of this product
as well as the motor.
•
Deliver this manual to the end user of this product. Keep this manual in a safe place until this
product is discarded.
• For how to use an optional device, refer to the instruction and installation manuals for that optional
device.

Fuji Electric FRENIC-Ace series Specifications

General

Series	FRENIC-Ace
Category	Inverter
Manufacturer	Fuji Electric
Frequency Range	0.1 to 400 Hz
Humidity	95% RH or less (non-condensing)
Output Frequency	0 to 400 Hz
Protection Functions	Overcurrent, overvoltage, undervoltage, overload, overheating, short circuit, ground fault
Braking Unit	Built-in (standard models) or external (optional)
Communication	Ethernet
Overload Capacity	150% of rated current for 60 seconds
Cooling Method	Forced air cooling
Enclosure Rating	IP20
Ambient Operating Temperature	-10 to +50°C
Altitude	1000m or less (derating above 1000m)