Fuji Electric FRENIC-Ace series - CC-Link Communications Card (OPC-CCL)

11.21 CC-Link communications card (OPC-CCL)
11-67
SELECTING PERIPHERAL EQUIPMENT
Chap 11
11.21 CC-Link communications card (OPC-CCL)
CC-Link (Control & Communication Link) is an FA open field network system.
The CC-Link communications card connects the inverter to a CC-Link master via CC-Link using a dedicated cable.
It supports the transmission speed of 156 kbps to 10 Mbps and the total length of 100 to 1,200 m so that it can be
used in wide range of systems requiring a high-speed or long-distance transmission, enabling a flexible system
configuration.
Note: Two or more communication cards cannot be mounted simultaneously. And this card requires a mounting
adapter; refer to Section 11.19 .
Note: It is not possible to use the built-in CAN interface, if OPC-CCL card is to be installed.
Applicable ROM version
This communications card is applicable to inverters with a ROM version 0300 or later.
11.21.1 CC-Link specifications
Table 11.21-1
Item Specifications
Applicable controller Mitsubishi Electric sequencer, etc. (CC-Link master)
Transmission system
CC-Link version 1.10 and 2.0
(Broadcast polling system)
Number of inverters connectable Max. 42 units (one station occupied/unit)
Number of stations occupied
CC-Link version 1.10: 1 station occupied
CC-Link version 2.0: 1 station occupied
(Selectable from among 2×, 4× and 8× settings)
Transmission speed (Baud rate) 10 Mbps/5 Mbps/2.5 Mbps/625 kbps/156 kbps
Maximum cable length
(When using the CC-Link
dedicated cable)
10 Mbps 5 Mbps 2.5 Mbps 625 kbps 156 kbps
100 m (328 ft)
150 m (492 ft)
200 m (656 ft)
600 m (2000 ft)
1200 m
(3900 ft)
Insulation 500 VDC (photocoupler insulation)
Station type Remote device station
Remote device type Inverter (0x20)
For items not contained in the above table, the CC-Link specifications apply.