Fuji Electric FRENIC-Ace series - Setting up Basic Function Codes Quickly Quick Setup: *Fnc

3.4 Programming Mode
3-38
3.4.8 Setting up basic function codes quickly “Quick Setup:
*fnc
”
Menu #0 “Quick Setup” in Programming mode allows you to quickly display and set up a predetermined basic set of
function codes.
To use Menu #0 “Quick Setup,” you need to set function code E52 to “0” (Function code data setting mode) or “2”
(Full-menu mode).
The predefined set of function codes that are subject to quick setup is stored in the inverter.
Figure 3.4-6 shows the menu transition in “Quick Setup” and function code data changing procedure.
Figure 3.4-6 Menu Transition in Menu #0 “Quick Setup” and Function Code Data Changing Procedure