Fuji Electric FRENIC-Ace series - Options for Communication and Operation Overview

11.19 Options for communication and operation overview
11-64
11.19 Options for communication and operation overview
In FRENIC Ace it is possible to install one communication card and one terminal block type option card. A mounting
adapter is required to install the communication card to the inverter.
11.19.1 Mounting adapter ( for communication option card)
This adapter is required for mounting the communication option card to FRENIC-Ace.
Table 11.19-1
Type Option Name Functions
OPC-E2-ADP1
Option card mounting adapter for
small-size inverter.
FRN0001E2■-2 to FRN0069E2■-2.
FRN0002E2■-4 to FRN0044E2■-4.
FRN0001E2■-7 to FRN0011E2■-7.
OPC-E2-ADP2
Option card mounting adapter for
mid-size inverter.
FRN0059E2■-4 and FRN0072E2■-4.
OPC-E2-ADP3
Option card mounting adapter for
large-size inverter.
FRN0085E2■-4 or above.
11.19.2 Communication option cards (required mounting adapter required)
Table 11.19-2
Type Option Name Functions Refer
OPC-DEV
DeviceNet
communications
card
This card enables the FRENIC-Ace to interface with
DeviceNet and the FRENIC-Ace can be operated as a
DeviceNet slave.
Section 11.20
OPC-CCL
CC-Link
communications
card
This card enables the FRENIC-Ace to interface with
CC-Link and the FRENIC-Ace can be operated as a
CC-Link slave.
Section 11.21
OPC-DIO
Digital I/O
interface card
DI: The frequency set-point can be given by 8, 12 bits
binary code or BCD code(0 to 99.9/0 to 999) and
extended 13 digital inputs are available mounting
this card.
DO: The monitoring with 8bit binary code and the
extended digital outputs (up to 8 outputs) are
available.
Section 11.22
OPC-AIO
Analog I/O
interface card
This card enables the FRENIC-Ace to input analog
set-points to the inverter and output analog monitors.
Section 11.23
OPC-PDP3
PROFIBUS-DP
communications
card
This card enables the FRENIC-Ace to interface with
PROFIBUS DP and the FRENIC-Ace can be operated
as a PROFIBUS DP slave.
Comming soon.
OPC-ETH2
EtherNet/IP
communications
card
This card enables the FRENIC-Ace to interface with
EtherNet and the FRENIC-Ace can be operated as a
EtherNet slave.
Comming soon.
OPC-PRT
ProfiNet-RT
communications
card
This card enables the FRENIC-Ace to interface with
ProfiNet-RT and the FRENIC-Ace can be operated as a
ProfiNet-RT slave.
Comming soon.
OPC-COP
CANopen
communications
card
This card enables the FRENIC-Ace to interface with
CANopen and the FRENIC-Ace can be operated as a
CANopen slave.
The built-in CAN cannot be used with PG option.
However, CAN communication and PG option can be
used at the same time by using this card.
Comming soon.