Chapter 4
TEST RUN PROCEDURE
This chapter describes basic settings required for making a test run.
Contents
4.1
Test Run Procedure Flowchart ·················································································· 4-1
4.2 Checking Prior to Powering On ················································································· 4-2
4.3 Powering ON and Checking ····················································································· 4-3
4.4 Destination setting ································································································· 4-4
4.5 Switching the Applicable Motor Rating (ND, HD, HND and HHD Modes) ···························· 4-6
4.6 Selecting a Desired Motor Drive Control ····································································· 4-8
4.6.1 V/f control with slip compensation inactive for IM ··················································· 4-8
4.6.2 Vector control without speed sensor (Dynamic torque vector) for IM ·························· 4-8
4.6.3 V/f control with slip compensation active for IM ····················································· 4-9
4.6.4 V/f Control with speed sensor for IM ··································································· 4-9
4.6.5 V/f Control with speed sensor with Auto Torque Boost for IM ···································· 4-9
4.6.6 Vector Control with speed sensor for IM ······························································ 4-9
4.6.7 Vector Control without speed sensor and magnetic pole position sensor for PMSM ····· 4-10
4.7 Performance Comparison for Drive Controls (Summary) ··············································· 4-11
4.8 Configuring Function Codes for Drive Controls ···························································· 4-12
4.8.1 Driving an Induction Motor (IM) ········································································ 4-13
[ 1 ] Driving a non-Fuji motor or Fuji non-standard IM under the V/f control ······················ 4-13
[ 2 ] Driving a Fuji general-purpose IM under the V/f control ·········································· 4-14
[ 3 ] Driving an IM under the V/f control with speed sensor ··········································· 4-15
[ 4 ] Driving a non-Fuji motor or Fuji non-dedicated IM under vector control with/without
speed sensor ······························································································· 4-16
[ 5 ] Driving a Fuji dedicated IM (MVK series) under vector control with speed sensor ········ 4-20
4.8.2 Driving a permanent magnet synchronous motor (PMSM) without pole sensor and
magnetic pole position sensor ·········································································· 4-21
[ 1 ] Driving a non-Fuji PMSM ················································································ 4-21
[ 2 ] Driving a Fuji dedicated PMSM (GNB2 series) ····················································· 4-26
[ 3 ] Driving a Fuji non-dedicated PMSM (non-GNB2 series) ········································· 4-26
4.9 Running the Inverter for Motor Operation Check ·························································· 4-27
4.9.1 Test run procedure ························································································ 4-27
4.9.2 Check points during a test run ·········································································· 4-27
4.9.3 Modification of motor control function code data ··················································· 4-28
To Next Page
Loading...
