Fuji Electric FRENIC-Ace series - Running or Stopping the Motor

3.3 Running Mode
3-8
3.3.3 Running or stopping the motor
By factory default, pressing the key starts running the motor in the forward direction and pressing the key
decelerates the motor to stop. The key is enabled only in Running mode.
When the inverter is running, the RUN LED lights.
To run the motor in the reverse direction or to run it reversibly, change the data of function code F02 to “3” or “0,”
respectively.
Note: The rotation direction of IEC-compliant motors is opposite to the one shown above.
Table 3.3-2 Motor Rotation Direction Specified by F02
Data for F02
Pressing the key runs the motor:
0 In the direction commanded by terminal [FWD] or [REV]
1
Disable key (The motor is driven by terminal [FWD] or [REV] command.)
2 In the forward direction
3 In the reverse direction
STOP key
RUN key
RUN LED