Fuji Electric FRENIC-Ace series - Attachment and Connection of Keypad

2.3 Attachment and Connection of Keypad
2-55
INSTALLATION AND WIRING
Chap 2
2.3 Attachment and Connection of Keypad
2.3.1 Parts required for connection
The following parts are necessary when attaching the keypad to locations other than the inverter main body.
Part name Type Remarks
Keypad extension cable (note 1) CB-5S, CB-3S, CB-1S Three lengths available (5 m, 3 m, 1 m) (3.3ft, 9.8ft, 16.4ft)
Keypad fixing screws
M3×

(note 2)
2 screws required (prepared by user)
(Note 1) When using commercially available LAN cable, use 10BASE-T/100BASE-TX straight cables (below 20
meters) which meet the ANSI/TIA/EIA-568A category 5 standards of U.S.A.
Recommended LAN cable
Manufacturer: Sanwa Supply, Inc.
Type: KB-10T5-01K (for 1 meter)
KB-STP-01K (for 1 meter) (shielded cable when conforming to EMC directive)
(Note 2) When attaching to the cabinet, use a fixing screw of appropriate length to the cabinet thickness.
2.3.2 Attachment procedure
The keypad can be attached in the following forms.
 Attach to the inverter main body (refer to Figure 2.3-1 (a), (b), (c))
 Attach to the cabinet (refer to Figure 2.3-2)
 Operate the panel remotely, on the hand (refer to Figure 2.3-3)
(a) FRN0069E2S-2 (b) FRN0072E2■-4 (c) FRN0203E2■-4
Figure 2.3-1 Attaching the Keypad to the Inverter Main Body
Figure 2.3-2 Attaching the Keypad on the Cabinet
Figure
2.3-3 Operating the Keypad Remotely,
on the Hand
Keypad
Keypad
Cabinet
Extension cable for
remote operation
Extension cable for
remote operation
Inverter main body
Keypad
Keypad fixing screws
Keypad
Inverter main body
Keypad