Fuji Electric FRENIC-Ace series - Configuring Function Codes for Drive Controls

4.8 Configuring Function Codes for Drive Controls
4-12
4.8 Configuring Function Codes for Drive Controls
The relation of the motor control method, motor selection and motor parameter setting is shown in Figure 4.8-1.
It is necessary to change the motor parameter setting depending on the driven motor.
V/f control for IM
(F42 = 0, 2)
V/f control for IM
with speed sensor
(F42 = 3)
Vector control for IM
with speed sensor
(F42 = 6)
Configure function
codes
concerning a PG
and PG signals
Configure function
codes
concerning a PG
and PG signals
Vector control without
speed sensor for IM
(Dynamic torque
vector)
(F42 = 1)
Non - Fuji
or Fuji non - standard IM
(P99 = 4)
Fuji standard IM
(8-series) (P99 = 0)
Tune motor parameters or
Set motor parameter
(Get them from a motor
manufacturers.)
Set F04,F05,P02 and P03.
Any motor
Set P02 and H03=2
(Apply factory defaults)
V/f control for IM
with speed sensor
(F42 = 4)
Configure function
codes
concerning a PG
and PG signals
IM
Select a motor drive control Select a motor type
Non - Fuji or
Fuji non-standard IM
(P99 = 4)
Fuji standard IM
(MVK - series) (P99 = 4)
Tune motor parameters or
Set motor parameters
(Get them from a motor
manufacturers.)
Set motor parameters
(Get them from Fuji.)
Non-Fuji or
Fuji non - standard IM
(P99 = 4)
IM
Vector control for
PMSM
without speed sensor
and magnetic pole
position sensor
(F42 = 15)
Non - Fuji PMSM
(P99 = 20)
Fuji PMSM
(GNB2 - series) (P99 = 21)
Tune motor parameters or
Set motor parameters
(Get them from a motor
manufacturers.)
Set P02 and H03=2 after
setting F42=15.
(Apply factory defaults)
PMSM PMSM
Select PMSM type
and pole position
detection method
Figure 4.8-1
Factory defaults are set to drive the induction motor with V/f control. (F42 = 0)
The motor can not be driven properly
if the synchronous motor is connected.
If the synchronous motor is driven, it is necessary to set F42=15
to change the drive control mode
for
driv
ing the synchronous motor.
It is also necessary to set the motor
parameters for the synchronous motor. Refer to “4.6.7
Vector Control
without speed sensor and m
agnetic pole position sensor for PMSM” for the explanation of the test run
of
the synchronous motor.
If F42 is changed to any other value from 15 or vice versa, setting related to motor parameters such as
F04, F05
, P01, etc… will be changed, In this case, re-configuration is required. For details, refer to
Chapter
5
“5.3.4 P codes (Motor 1 parameters)”.
The test run seems to be better to be executed under speed control (H18=0) temporarily even if torque
control is required.
It is recommended to change to torque control (H18 = 2 or 3) after checking
that the
operation is normal in
the test run.