Fuji Electric FRENIC-Ace series - Removal and Attachment of the Front Cover; Terminal Cover and Wiring Guide

2.2 Wiring
2-6
Route the wiring following the steps below. The descriptions assume that the inverter is already fixed to the
cabinet.
2.2.2 Removal and attachment of the front cover/ terminal cover and wiring guide
Always remove the RS-485 communication cable from the RJ-45 connector before removing the front cover.
Risk of fire and risk of accidents exist.
(1) Types FRN0020E2
■
-2

/ FRN0012E2
■
-4

/ FRN0011E2
■
-7

or below
1) Loosen the screws of the terminal cover. To remove the terminal cover, put your finger in the dimple of the
terminal cover and then pull it up toward you.
2) Pull out the wiring guide toward you.
3) After routing the wires, attach the wiring guide and the terminal cover reversing the steps above.
Figure 2.2-3 Removal of the Terminal Cover and the Wiring Guide (for FRN0006E2S-2)
(2) Types FRN0030E2
■
-2

to FRN0069E2
■
-2

and FRN0022E2
■
-4

to FRN0044 E2
■
-4

1) Loosen the screws of the terminal cover. To remove the terminal cover, put your finger in the dimple of the
terminal cover and then pull it up toward you.
2) Pull out the wiring guide toward you.
3) After routing the wires, attach the wiring guide and the terminal cover reversing the steps above.
Figure 2.2-4 Removal of the Terminal Cover and the Wiring Guide (for FRN0069E2■-2)