Fuji Electric FRENIC-Ace series - Operation Using the Keypad

Chapter 3
OPERATION USING THE KEYPAD
This chapter describes keypad operation of the inverter.
Contents
3.1
Names and Functions of Keypad Components ····························································· 3-1
3.2 Overview of Operation Modes ·················································································· 3-3
3.3 Running Mode ······································································································ 3-5
3.3.1 Monitoring the running status ············································································ 3-5
3.3.2 Monitoring light alarms ···················································································· 3-7
3.3.3 Running or stopping the motor ·········································································· 3-8
3.3.4 Setting up reference frequency from the keypad ··················································· 3-9
3.3.5 Setting up PID commands from the keypad ························································ 3-10
[ 1 ] Settings under PID process control ··································································· 3-10
[ 2 ] Settings under PID dancer control ····································································· 3-12
3.3.6 Jogging operation ·························································································· 3-14
3.3.7 Remote and local modes ················································································ 3-15
3.4 Programming Mode ······························································································· 3-16
3.4.1 Setting up function codes “Data Setting: !f__ through !o__ ” ······························· 3-17
3.4.2 Checking changed function codes “Data Checking: "rep ” ·································· 3-18
3.4.3 Monitoring the running status “Drive Monitoring: #ope ” ······································· 3-19
3.4.4 Checking I/O signal status “I/O Checking: $i_o ” ················································ 3-23
3.4.5 Reading maintenance information “Maintenance Information: %che ” ····················· 3-27
3.4.6 Reading alarm information “Alarm Information: &al ” ············································ 3-31
3.4.7 Copying data “Data Copying: 'cpy ” ······························································· 3-34
3.4.8 Setting up basic function codes quickly “Quick Setup: *fnc ” ······························· 3-38
3.5 Alarm Mode ········································································································· 3-40
3.5.1 Releasing the alarm and switching to Running mode ············································ 3-40
3.5.2 Displaying the alarm history ············································································· 3-40
3.5.3 Displaying the status of inverter at the time of alarm ············································· 3-40
3.5.4 Switching to Programming mode ······································································ 3-40