Fuji Electric FRENIC-Ace series - Test Run Procedure Flowchart

4.1 Test Run Procedure Flowchart
4-1
TEST RUN PROCEDURE
Chap 4
4.1 Test Run Procedure Flowchart
Make a test run of the motor using the flowchart given below.
This chapter describes the test run procedure with motor 1 dedicated function codes that are marked with an
asterisk (*). For motor 2, replace those function codes with asterisk with motor 2 dedicated ones.
 For the function codes dedicated to motor 2, see Chapter 5 “FUNCTION CODES.”
Switch the Applicable Motor Rank by F80
( ND,HD,HND and HHD modes)
Power ON check.
Check prior to powering on.
Mount the inverter,perform wiring and set
up slide switches on the control PCB.
Select a motor drive control mode and
motor type (set motor parameters)
Run the Inverter for operation check.
(gradually accelerating from low to high
speed)
Select a Frequency Command Source.
Select a Run Command Source
End
(Proceed practical operation)
Start
Setting the Destination
( Asia, EC, USA modes)
Figure 4.1-1 Test Run Procedure
(See Chapter 2.)
(See Section 4.2 .)
(See Section 4.3 .)
(See Section 4.4 .)
(See Section 4.5 .)
(See Section 4.6 to 4.8 .)
(See Section 4.9 .)
(See Section 4.10 .)
(See Section 4.11 .)