Fuji Electric FRENIC-Ace series - Acceptance Inspection (Nameplates and Inverter Type)

1.1 Acceptance Inspection (Nameplates and Inverter Type)
1-1
BEFORE USE
Chap 1
1.1 Acceptance Inspection (Nameplates and Inverter Type)
Unpack the package and check the following:
(1) An inverter and the following accessories are contained in the package.
Accessories - DC reactor (for ND-mode inverters of FRN0139E2■-4G or above, HD/HND-mode inverters
of FRN0168E2■-4G or above, and HHD-mode inverters of FRN0203E2■-4G or above)
(Not included with the FRN****E2■-4C(china model)
- Keypad rear cover (with three screws for securing the keypad)
- Instruction manual
- CD-ROM (containing the FRENIC-Ace User's Manual)
(2) The inverter has not been damaged during transportation—there should be no dents or parts missing.
(3) The inverter is the type you ordered. You can check the type and specifications on the main nameplate. (The
main and sub nameplates are attached to the inverter as shown on Figure 1.2-1.)
(a) Main Nameplate (b) Sub Nameplate
Figure 1.1-1 Nameplates
TYPE: Type of inverter
Figure 1.1-2 Type of inverter