Fuji Electric FRENIC5000G11S Series - Page 61

INVERTER SIO Driver
GP-Pro EX Device/PLC Connection Manual
61
• The recommended connection cable is the Furukawa Electric ' s AWM2789 long-distance cable.
• Set the termination resistance switch on the External Device as follows:
*3 All GP3000 models except the GP-3200 Series and AGP-3302B
*4 Only a COM port which can communicate by RS-422/485 (2-wire) can be used. (Except PE-4000B, PS5000)
) IPC COM Port (page 5)
*5 Except GP-4203T
*6 All GP4000 models except GP-4100 Series, GP-4*01TM, GP-Rear Module, GP-4201T and GP-4*03T
*7 Except SP-5B00
*8 When using a Terminal Block Conversion Adapter (CA3-ADPTRM-01) instead of the RS-422 Terminal Block
Conversion Adapter, refer to Cable Diagram 3A.
*9 Only a COM port which can communicate by RS-422/485 (2-wire) can be used.
) IPC COM Port (page 5)
Series Switch Setting
FRENIC-MEGA SW2 ON
FRENIC-Eco
OPC-F1-RS card
SW103 ON
• Depending on the operating environment, malfunctions may occur due to External
Device noise. In this case, connect the ferrite core to the cable.
Display External Device
DX-
DX+
FG
SDB
SDA
Ferrite core
RS-485
communication
cable
Pass the same-phase wires through
or turn them around the ferrite core
2 or 3 times.