Fuji Electric MICREX-SX Series SPH - Page 7

1-3
Section1 Standards Conformed Product
Component Type Specification CE UL cUL LR NK
Dummy module NP1F-DMY substitute for the failed module yes no no no no
To adapt to
CE
marking,
the
measures
described
in 2-2-3
need to be
taken.
High-speed counter
module
NP1F-HC2 2 channels 500kHz yes
no no no no
NP1F-HC8 8 channels 50kHz yes
no no no no
Pulse train output
module
NP1F-HP2
Pulse train command, 2 channels 250kHz
Forward pulse + reverse pulse
yes
no no no no
Pulse train multiple
module
NP1F-MP2
Positioning control multiple module
2 axes, Pulse train command
yes
no no no no
Analog
multiplemodule
NP1F-MA2
Positioning control multiple module
2 axes, Analog command
yes
no no no no
Signal converter NP2F-LEV
Convert signal level, From open collector signal to
RS-485 or vice versa
yes
no no no no
D300win cable
NP4H-CNV Personal computer cable for loader with converter yes yes yes yes yes
NP4H-CA2 Personal computer cable for loader yes yes yes yes yes
Simulative-input swich NP8X-SW 16 points yes yes yes yes yes
Data backup battery NP8P-BT Lithium primary battery yes yes yes yes yes
User ROM card NP8PMF-16
User ROM card 16k steps Dedicated to standard
CPU
yes yes yes yes yes
CPU mode selection
key swich
NP8P-KY For CPU mode selection yes yes yes yes yes
Base board mounting
stud
NP8P-ST For DIN rail (in pairs) yes yes yes yes yes
SX bus terminating
plug
NP8P-BP For SX bus terminating yes yes yes yes yes
T-link connector,
JPCN-1 connector
FCT120T yes yes yes yes yes
P/PE-link connector FTC120P yes yes yes yes yes
T-link/JPCN-1
terminating resistor
FRT120A100 100Ω/1W yes yes yes yes yes
P/PE terminating
resister
FRT220A75 75Ω/1W yes yes yes yes yes
I/O connector,
Positioning control
module connector
NP8V-CN
Soldered socket type,connector cover
(Fujitsu Co.,Ltd.)
yes yes yes yes yes