15 Problem Solving
490
Problem Solving
15
027-445
[Cause] IP address for IPv6 set manually is incorrect.
[Remedy] Set the IP address correctly.
027-446
[Cause] The IP address of IPv6 set manually already exists.
[Remedy] Change the [Manually Configured IPv6 Address] on the machine, or the
IP address of IPv6 on the network device, to remove the duplication of
addresses.
027-447
[Cause] The IP address of IPv6 already exists.
[Remedy] Change the [Link-local Address] for IPv6 on the machine, or the IP
address of IPv6 on the network device, to remove the duplication of
addresses.
027-452
[Cause] IP address of IPv4 already exists.
[Remedy] Change the IP address of IPv4 set on the machine or the IP address of
IPv4 on the network device.
027-500
[Cause] Unable to connect to the SMTP server.
[Remedy] Specify the SMTP server name correctly or specify the server by using
its IP address.
027-501
[Cause] An POP server error occurred.
[Remedy] Execute the operation again. If the error still is not resolved, contact our
Customer Support Center.
027-502
[Cause] Failed to log into the POP3 server when using the POP3 protocol.
[Remedy] Confirm whether the user name and password used in the POP3 server
are correct on CentreWare Internet Services.
027-503
[Cause] An POP server error occurred.
[Remedy] Execute the operation again. If the error still is not resolved, contact our
Customer Support Center.
027-504
[Cause] A SMTP server error occurred.
[Remedy] Execute the operation again. If the error still is not resolved, contact our
Customer Support Center.
027-513
[Cause] The machine failed to transfer data using SMB of the Scan to PC service
because access to the SMB server was not permitted.
[Remedy] Consult your system administrator for settings.
Error Code Cause and Remedy
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
To Next Page
Loading...
