15 Problem Solving
550
Problem Solving
15
4 After you pull out the staple cartridge, check
inside of the finisher for any remaining
staples.
5 Pull up the metal part of the staple cartridge
as shown in the illustration.
6 Remove the jammed staples (1), and then
return the metal part pulled up in step 5 to
the original position (2).
7 Push the staple cartridge into the machine
until it clicks into place.
8 Close the finisher front cover.
Note • If the finisher front cover is not completely closed, a message will appear and the machine
remains paused.
If you cannot remove jammed staples even after you perform the above procedure,
contact our Customer Support Center.
CAUTION
Be careful in removing jammed staples.
1
2
To Next Page
Loading...
Need help?
General
