Broadcast
233
Fax
4
DTMF Method
The following two types are available in the DTMF method: Auto Send and Manual
Send.
Auto Send (Transmitting without picking up the receiver)
1 Select [New Recipients] to display the keyboard on the touch screen and enter the
destination and password in the following format.
z
Password
A pre-registered 2-digit number
Note • By default, no password is set. Contact our Customer Support Center to set a password. If a
password is not set, you do not need to enter one.
z
Relay station ID
The last two digits of the initiating station address number registered at the relay station
z
Address number
An address number for the relay recipients registered at the relay station
The wildcard "∗" can also be used.
You can register the above dialing format in an address number to send using the address number. For
information on how to register address numbers, refer to "5 Tools" > "Setup" > "Add Address Book
Entry" in the Administrator Guide.
2 Select [+ Add] to perform Multiple Relay Broadcast.
Note • You can specify up to 20 locations for relay recipients.
3 Press the <Start> button.
Manual Send (Transmitting with picking up the receiver or on-hook)
1 Select the [More Options] tab to display the
[More Options] screen.
2 Pick up the telephone receiver, or select
[On-hook (Manual Send/Receive)].
3 Select [Manual Send] from the drop-down
menu.
To Next Page
Loading...
