3 Maintenance
74
Maintenance
3
2 Hold the tabs on both sides of the staple
cartridge and pull the cartridge out of the
finisher.
3 Hold the tabs on both sides of a new staple
cartridge, and insert it into the original posi-
tion until it clicks.
4 Repeat steps 2 and 3 to replace the other staple cartridge.
5 Close the finisher side cover.
Note • If the cover is not completely closed, a message will appear and the machine remain
paused.
Replacing Staple Cartridge (for Finisher-C1 with Booklet Maker)
When the optional Finisher-C1 with Booklet Maker is installed and the staple cartridge
needs to be replaced, a message appears on the touch screen. When this message
appears, load a new staple case into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and
performance. Use only staple cartridges recommended by Fuji Xerox.
Note • To order a staple cartridge, contact our Customer Support Center.
1 Make sure that the machine is not operating,
and open the finisher front cover.
2 While pressing the handle R2 and handle R3
to the right (1), take the staple cartridge unit
out of the finisher (2).
R2
R3
To Next Page
Loading...
Need help?
General
