Fuji Xerox apeosport-iv C3370 - Outgoing;Incoming E-Mail Settings

Connectivity & Network Setup
183
Tools
5
HTTPS Proxy Server Authentication
Select [Enabled] when authentication is required to connect to the HTTPS proxy server.
HTTPS Proxy Server Login Name
Enter a login name of the HTTPS proxy server. Up to 31 characters are allowed.
HTTPS Proxy Server Password
Enter a password of the HTTPS proxy server. Up to 31 characters are allowed.
Outgoing/Incoming E-mail Settings
Set e-mail transmission and reception settings.
POP3 Server Settings
Set the POP3 server. In [POP3 Server Settings], you can set the following items:
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value
from 0 to 255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where
"xxxx" is a hexadecimal value.
• When you make an entry mistake, press the <C> (Clear) button and enter again.
Server Name/IP Address
Enter a server name or IP address with up to 128 characters, and then select [Save].
Port Number
Enter a port number from 1 to 65535.
The default value is 110.
Important • Do not use the numbers assigned to the other ports.
Polling Interval
Set the interval for checking the e-mail on the POP3 server from 1 to 120 minutes in 1 minute
increments.
Login Name
Enter the name to login to the POP3 server with up to 64 characters.
Password
Enter a password for the POP3 server with up to 64 characters.
Enter the same password in [New Password] and [Retype Password] using the numeric
keypad displayed by selecting [Keyboard]. If you do not set the password, leave the text
boxes blank and select [Save].
POP Password Encryption
Select [On (APOP)] to encrypt the password.
SMTP Server Settings
Set the SMTP server. In [SMTP Server Settings], you can set the following items:
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value
from 0 to 255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where
"xxxx" is a hexadecimal value.
• When you make an entry mistake, press the <C> (Clear) button and enter again.
SMTP Server Name/IP Address
Enter a server name or IP address, and then select [Save]. Up to 128 characters are allowed.