14 Problem Solving
508
Problem Solving
14
033-538
033-539
033-540
O [Cause] An error occurred during fax transmission.
[Remedy] Execute the operation again. If the error still is not
resolved, contact our Customer Support Center.
033-541
O [Cause] The recipient is not specified.
[Remedy] Specify the recipient correctly.
033-542
O [Cause] A line was specified that is not connected.
[Remedy] Specify a connected line.
033-543
O [Cause] The recipient (fax number) is incorrect.
[Remedy] Enter a correct fax number, and execute the operation
again.
033-544
O [Cause] The recipient's line is busy.
[Remedy] Wait for a while, and then execute the operation again.
033-545
O [Cause] The other machine may not be a facsimile.
[Remedy] Check whether the other machine is a facsimile.
033-546
O [Cause] A dial tone was not detected.
[Remedy] Check whether the line is connected correctly.
033-547
O [Cause] Communication was terminated by a cause such as
pressing the <Stop> button.
[Remedy] No measure is required.
033-548
O [Cause] Cannot transmit manually because a line is unavailable.
[Remedy] Establish communication such as by telephone, and
execute the operation again.
033-549
O [Cause] Cannot use the Fax service because of causes such as
memory is insufficient.
[Remedy] Wait for a while, and execute the operation again.
033-550
O [Cause] Cannot execute another job because fax communication is
in progress.
[Remedy] Wait until the job being communicated completes, and
then execute the operation again.
033-551
O [Cause] You attempted to change a job immediately before fax or
telephone communication completed.
[Remedy] Wait for a while, and execute the operation again.
033-552
O [Cause] The total quantity of error lines detected with G3 exceeded
the set value.
[Remedy] Confirm the model of the other machine, and execute the
operation again. If receiving, ask the sender to send again.
033-553
O [Cause] This machine does not have confidential or relay function.
The F-code sent from the other machine contains an
instruction for a function not supported by the machine.
[Remedy] If necessary, check whether the sender entered an invalid
F-code.
033-554
O [Cause] The password was omitted or did not match in fax
communication.
[Remedy] No measure is required.
Error Code
Category
Cause and Remedy
CPFSMO
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
To Next Page
Loading...
Need help?
General
