Installation Procedures
369
Using IP Fax (SIP)
10
For information on how to print a configuration report, refer to "Print Reports" (P.106).
Step 2 Configuring the SIP User Name
This section describes the configuration procedures of the SIP user name on the machine.
You can configure the settings using CentreWare Internet Services. For information on how to use CentreWare Internet
Services, refer to "Configuring Machine Settings Using CentreWare Internet Services" (P.313) .
1 Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator’s user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools] on the [Services Home] screen.
2 Set SIP User ID.
1) Select [Connectivity & Network Setup].
2) Select [SIP settings].
3) Select [SIP User ID (Sign-in Name)], and then select [Change Settings].
4) Enter a SIP User ID and select [Save].
For information on SIP User ID, refer to "SIP Settings" (P.207).
3 Select [Close] repeatedly until the [Tools] screen is displayed.
4 Select [Close].
Note • Rebooting the machine may be required depending on the settings. When a message displayed on
the screen, follow the message and reboot the machine.
5 Print a configuration report to confirm that the port is enabled and TCP/IP setting is set up
correctly.
For information on how to print a settings list, refer to "Print Reports" (P.106).
Step 3 Configuring Fax Environment
This section describes the configuration procedures of the Fax feature related to IP fax (SIP)
on the machine.
You can configure the settings using CentreWare Internet Services. For information on how to use CentreWare Internet
Services, refer to "Configuring Machine Settings Using CentreWare Internet Services" (P.313).
1 Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator’s user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools] on the [Services Home] screen.
To Next Page
Loading...
Need help?
General
