EasyManuals Logo

Fuji Xerox ApeosPort-V 4070 Administrator's Guide

Fuji Xerox ApeosPort-V 4070
719 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #144 background imageLoading...
Page #144 background image
5 Tools
144
Tools
5
Delete All Data
This feature is designed to prevent the leakage of confidential information of a customer
when the machine is returned to Fuji Xerox. All data stored on the machine will be deleted.
Before executing the operation, make sure that the operation is absolutely necessary.
Note • It takes several minutes to several hours to delete all data. (The time taken depends on the machine
configuration or the hard disk capacity.)
Software Options
This feature is for service representative use. For more information, contact our Customer
Support Center.
Power on Self Test
Set whether or not to perform self test when the machine is turned on and started up.
If any abnormal condition such as intentional program modification is found during the
program diagnosis, the machine stops starting up and records the information in the audit
log.
Note • The information may not be recorded in the audit log depending on the status of program
malfunction.
• If the machine does not start, contact our Customer Support Center.
Check Smart Card Details
When you select [Check Smart Card Details] and touch your smart card to the smart card
reader, the information of the smart card appears on the touch screen.
Note • You can register the authentication information using CentreWare Internet Services. For more
information, refer to the help of CentreWare Internet Services.
Important •To display the online help for CentreWare Internet Services, users need to have the environment to
connect to the Internet. The communication fee shall be borne by you.
Finisher Adjustment
This feature is available when the Finisher-B1/Booklet Maker Unit for Finisher-B1 is installed
with a hole punch kit or C3 Finisher/C3 Finisher with Booklet Maker is installed with a punch
unit.
îš„ Hole Punch Tool
Specify either [2/4 Hole Punch] or [2/3 Hole Punch (US Specification)].
îš„ Adjust Booklet Fold Position
Set the booklet fold position for paper smaller or larger than B4.
îš„ Adjust Fold Position
You can adjust the fold position for each paper type and can set up to 10 adjustment type.
Also, you can assign the type to each tray.
z
Fold Position Type Setup
Adjust the position for Single Fold, Booklet, C Fold, Z Fold, and Z Fold Half Sheet.
For more information on setting procedures, refer to "Fold Position Adjustment" (P.601).
z
Trays 1 to 4, and 6
Assign an adjustment type to each tray.
îš„ Fold Assisting Crease
Set the number of additional folding lines between the specified fold line to prevent the
output of the folded booklet from opening.

Table of Contents

Other manuals for Fuji Xerox ApeosPort-V 4070

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fuji Xerox ApeosPort-V 4070 and is the answer not in the manual?

Fuji Xerox ApeosPort-V 4070 Specifications

General IconGeneral
BrandFuji Xerox
ModelApeosPort-V 4070
CategoryAll in One Printer
LanguageEnglish

Related product manuals