Customizing the Control Panel
33
Before Using the Machine
1
4
Select [System Settings] > [Common Service
Settings] > [Screen/Button Settings].
5
Select [Services Home - Additional Features],
and then select [Change Settings].
Note • Select [ ] to display the previous screen or
[ ] to display the next screen.
6
Select the position where you want to assign an
additional feature.
Note • Select [ ] to display the previous screen or
[ ] to display the next screen.
• The layout of the buttons in this screen
corresponds to the layout of those on the
Services Home screen.
7
Select a service you want to display on the
Services Home screen.
Note • Select [ ] to display the previous screen or
[ ] to display the next screen.
• You cannot assign the same feature to more
than one button.
8
Select [Save].
9
Select [Save].
Assigning Services to the Custom Buttons
You can assign services to the <Copy>, <(Not in Use)>, and <Review> buttons on the control
panel.
Assigning a service to a custom button allows you to switch to this service without having to
return to the Services Home screen. If you do not need to assign any service to a custom
button, select [(Not Set)].
[Copy] is assigned to the <Copy> button and [Review] is assigned to the <Review> button at
factory, while the <(Not In Use)> button has no assignment.
This section describes how to assign [Send from Folder] to the <(Not in Use)> button, as an
example.
Note • After you change the assignment, apply the labels provided with the machine. When you assign a
service for which no label is provided, use a blank label and write down the service name with a
permanent marker. The labels include the services that are not supported by the machine.
To Next Page
Loading...
