Fuji Xerox ApeosPort-V 4070 Administrator's Guide

Error Code
535
Problem Solving
15
047-213
[Cause] Detected the installation of a finisher of a different type than expected.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
047-214
047-215
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. Try again. If the error still is not resolved, contact our Customer
Support Center.
047-216
[Cause] An error occurred while detecting the finisher.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
047-217
[Cause] An error occurred while detecting Tray 6 (HCF B1) (optional).
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
047-218
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. Try again. If the error still is not resolved, contact our Customer
Support Center.
047-320
[Cause] An error occurred.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
058-314
[Cause] Temperature sensor of the machine detected abnormality.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the error still is not resolved, contact our Customer Support
Center.
059-316
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. Try again. If the error still is not resolved, contact our Customer
Support Center.
061-320
061-325
061-340
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
062-277
[Cause] A communication error occurred between the document scanning unit and the
document feeder.
[Remedy] Contact our Customer Support Center.
062-311
[Cause] An error occurred.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
062-328
062-329
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. Try again. If the error still is not resolved, contact our Customer
Support Center.
Error Code Cause and Remedy

Fuji Xerox ApeosPort-V 4070 Specifications

General

Brand	Fuji Xerox
Model	ApeosPort-V 4070
Category	All in One Printer
Language	English