Fuji Xerox ApeosPort-V 4070

Settings for the Secure Operation 2 (Initial Settings Procedures Using CentreWare Internet Services)
18
5
Set LDAP Server
1
Click [Connectivity] on the [Properties] screen.
2 Click [Protocols].
3 Click [LDAP].
4 Select [LDAP Server].
5 On each menu, set the LDAP Server information.
6 Click [Apply].
Set Kerberos Server
1
Click [Security] on the [Properties] screen.
2 Click [Remote Authentication Servers].
3 Select [Kerberos Server].
4 On each menu, set the Kerberos Server information.
5 Click [Apply].
Note • When a Kerberos server is used as a remote authentication server, you can register users who are
given the privileges of System Administrator (SA) by setting the [System Administrator Access
Group] on the LDAP server.
Set Service Representative Restricted Operation
1
Click [Security] on the [Properties] screen.
2 Click [Service Representative Restricted Operation].
3 Check the [Enabled] box for [Restricted Operation].
4 Enter a passcode in the [Maintenance Passcode] box.
5 Enter the same passcode in the [Retype Maintenance Passcode] box.
6 Click [Apply].
Set Audit Log
1
Click [Security] on the [Properties] screen.
2 Click [Audit Log].
3 Check the [Enabled] box for [Audit Log].
4 Click [Apply].