Replacing Consumables
91
Maintenance
3
6 Push the staple cartridge into the finisher until
it clicks into place.
7 Close the finisher front cover.
Note • If the front cover is not closed completely, a message appears and the machine will remain paused.
Replacing Staple Cartridge (for Finisher-B1)
When the Finisher-B1 (optional) is installed and the staple cartridge needs to be replaced, a
message appears on the touch screen. When this message appears, load a new staple case
into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and performance.
Use only staple cartridges recommended by Fuji Xerox.
Note • To order a staple cartridge, contact our Customer Support Center.
1 Make sure that the machine is not operating,
and open the finisher front door.
2 With grasping the handle, pull the staple
cartridge holder to the right, towards you.
3 Pull the staple cartridge out of the finisher.
Note • The staple cartridge is firmly inserted. A slight
force is required to pull the cartridge out of
the finisher.
To Next Page
Loading...
