Fuji Xerox Color C70

Output Format
147
Copy
3
 Image Position
z
Image Inside Fold
Folds copies so that the image is printed inside after you select [Z Fold], [C Fold], or [Single
Fold].
z
Image Outside Fold
Folds copies so that the image is printed outside after you select [Z Fold], [C Fold], or
[Single Fold].
 Trimming
When the Trimmer Squarefold (optional) is installed, this option is displayed if you select
[Single Fold].
[Trimming] Screen
When the Trimmer Squarefold (optional) is installed, [Trimming] becomes available if you
select [Single Fold] on the [Folding] screen.
Trimming is a feature that trims the fore edge of a booklet, which is opposite of the booklet
spine, in order to finish the edge neatly.
1 Select any item.
 Off
Does not trim the fore edge of booklets.
 On
Trims the fore edge of booklets.
 Paper Supply
Displays the [Paper Supply] screen. Select the paper tray to be used. Select the tray with
paper loaded in landscape orientation.
 Cut to Size
Displays the width of the finished booklet after being trimmed by the amount specified in
[Default Trim Margin]. Change the value as necessary.
Note • You can specify the value of [Default Trim Margin] in the System Administration mode. For more
information, refer to "5 System Settings" > "Copy Service Settings" > "Copy Control" > "Default Trim
Margin" in the Administrator Guide.
Preset Repeat Image (Making Multiple Copies on a Single Sheet)
This feature allows you to repeatedly copy one original onto equally divided areas according
to the specified number of copies.
You can select the number of the times the original is copied onto one sheet from [2 Times],
[4 Times], or [8 Times].