Error Code
379
Problem Solving
14
027-530
O [Cause] During the transfer using [SMB] of the [Scan to PC]
feature, a file could not be saved because [Cancel Job]
had been selected for [File Name Conflict].
[Remedy] Select any option other than [Cancel Job] for [File Name
Conflict].
027-531
O [Cause] During the transfer using [SMB] of the [Scan to PC]
feature, an error occurred because the filing policy was
invalid.
[Remedy] When selecting [Change Name and Save] in [File Name
Conflict], make sure that the file format is not Multi-Page.
027-532
O [Cause] During the transfer using [SMB] of the [Scan to PC]
feature, an error occurred when accessing to the
NEXTNAME.DAT file.
[Remedy] If [Change Name and Save] has been selected for [File
Name Conflict], check if the NEXTNAME.DAT file is
correct.
027-533
O [Cause] During the transfer using [SMB] of the [Scan to PC]
feature, an internal error occurred.
[Remedy] Try executing the same operation. If the error persists,
contact our Customer Support Center.
027-543
O [Cause] The SMB server (NetBIOS) name is invalid.
[Remedy] Check if the server name of the SMB server is correct.
027-547
O O [Cause] SMB protocol error. An invalid character was detected in
the specified domain name.
[Remedy] If the error occurred during SMB authentication:
Check with the network administrator for the domain
name, then re-configure correctly.
Also, check if the domain name set on the machine is
correct, using the following procedure:
1. Enter the System Administration mode, and select
[Tools] > [System Settings] > [Connectivity & Network
Setup] > [Remote Authentication Server / Directory
Service] > [SMB Server Settings].
2. Select the SMB server to check the domain name.
If the error occurred during the transfer via SMB of [Scan
to PC]:
Check the domain name which has been specified when
entering login name with the network administrator. To
check the domain name on the server, take the following
procedure:
1. Select [Start] > [Programs] > [Administrative Tools] >
[Active Directory Domains and Trusts] on the Active
Directory domain controller.
2. From the left side frame of the [Active Directory
Domains and Trusts] window, select [Active Directory
Domains and Trusts] > [Domains]. Right-click [Domains]
to select [Properties].
3. Select [General] tab in the domain properties window,
check the domain name (prior to Windows 2000).
Error Code
Category
Cause and Remedy
CPFSMO
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
To Next Page
Loading...
