3 Copy
152
Copy
3
îš„ Output/Offset
Allows you to select the output destination tray and offset operation.
z
Offset Stacking
This option is displayed when you select [Center Tray - Upper] or [Center Tray - Lower] for
the output destination. When an optional finisher is installed, this option is displayed
when you select [Center Tray] or [Right Middle Tray].
The offset is a function for slightly offsetting and outputting each paper stack to allow
you to distinguish the separations. You can select from [Offset per Set], [Offset per Job],
[Offset Every N Pages], [Offset Every N Sets], and [System Default].
Note • This feature does not appear for some models. An optional component is required. For more
information, contact our Customer Support Center.
• If you select [System Default], the setting in the System Administration mode will be effective. For
information on how to change the setting, refer to "5 Tools" > "Copy Service Settings" > "Copy
Defaults" > "Output Destination" in the Administrator Guide.
To Next Page
Loading...
Need help?
General
