Fuji Xerox DocuCentre-IV C3375 User Manual

8 Stored Programming
382
Stored Programming
8
Calling a Stored Program for Build Job
You can call a stored program for Build Job on the [Copy] screen displayed while Build Job
is running.
1 Select [Change Settings].
2 Select the [Job Assembly] tab.
3 Select [Stored Programming].
4 Select a number of a stored program containing the features you want to use.
Note • You can only select registered numbers.
• After the stored program has been called, the machine sounds an audible tone. If a failure occurs,
the machine sounds a fault tone.
For information on how to change the volume of the sound that notifies that a stored program has been called, refer to "5
Tools" > "Common Service Settings" > "Audio Tones" > "Stored Programming Complete Tone" in the Administrator Guide.

Fuji Xerox DocuCentre-IV C3375 Specifications

General

Print Resolution	1200 x 2400 dpi
Scan Resolution	600 x 600 dpi
Duplex Printing	Yes
Functions	Print, Copy, Scan, Fax
Memory	2 GB
Hard Disk Drive	160 GB
Connectivity	Ethernet, USB
Paper Size	A3, A4, A5, B5
Fax Transmission Speed	33.6 kbps
Operating System Compatibility	Windows, Mac, Linux