Layout Adjustment
337
Scan
5
• The recommended document size combinations are A4 portrait and A3 landscape, or B5 portrait
and B4 landscape. If another combination of document sizes is used, the documents can be fed at
an angle and may not be scanned properly.
Note • When you select [Enter Output Size] in [Reduce/Enlarge] and specify the output size in [Enter Output
Size], the scanned data is automatically reduced/enlarged to the specified size. However, since the
scanned image is not rotated, the image will be reduced/enlarged to fit the specified size while
keeping its orientation. For example, when an A3 landscape original is loaded and the output size is
set to A4 portrait, the scanned image is reduced to A5 landscape and printed on A4 portrait paper.
• If the document size cannot be detected automatically, a screen to enter the document size
appears.
1 Select [Mixed Size Originals].
2 Select any option.
îš„ Off
Select this option when all documents are of the same size.
îš„ On
When scanning documents of different sizes, the machine automatically detects the size of
each document.
îš„ Original Orientation
Specify the orientation of the loaded document.
When you load the top edge of the document against the left side of the document glass or
the document feeder, and then select [Sideways Images], the document is displayed in the
correct orientation when viewed on your computer screen.
Note • If the [Original Orientation] setting differs from the actual document orientation, the machine may
not detect the top of the document correctly.
z
Upright Images
Select this option when placing the top edge of the document against the top side of the
document glass or document feeder.
z
Sideways Images
Select this option when placing the top edge of the document against the left side of the
document glass or document feeder.
To Next Page
Loading...
Need help?
General
