Interface Cables
21
Before Using the Machine
1
Interface Cables
When you connect the machine directly to your computer, use the USB interface.
When you connect the machine to a network, use the Ethernet interface.
Using the USB Interface
The USB interface of the machine supports USB 2.0.
This section describes the installation procedures for the USB interface.
1
Press the power switch to switch off the power.
2
Make sure that the touc
h screen is blank and the <Power Saver> button is not lit.
3
Open the front cover.
4
Press the main power switch to the [ ] position to switch off the main power.
5
Remove the rear right cover.
6
Connect a USB cable to the USB 2.0 interface connector.
7
Return the rear right cover to its original position.
8
Connect the other end of the USB cable to the computer.
9
Press the main power switch to the [ ｜ ] position to switch on the main power.
10
Close the front cover.
11
Press the power switch to switch on the power.
12
Restart the computer.
z
For more information on setting items, refer to "Printer Environment Settings" (P.317).
Using the Ethernet Interface
The Ethernet interface of the machine supports the following three types.
z
1000BASE-T
To Next Page
Loading...
Need help?
General
