Connectivity & Network Setup
195
Tools
5
îš„ Primary Server Name/Address
Enter the primary server name or IP address.
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to
255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
îš„ Primary Server - Port Number
Set the primary server port number from 1 to 65535.
The default value is 88.
Important • Do not use the numbers assigned to the other ports.
îš„ Secondary Server Name/Address
Enter the secondary server name or IP address.
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to
255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
îš„ Secondary Server - Port Number
Set the secondary server port number in the range from 1 to 65535.
The default value is 88.
Important • Do not use the numbers assigned to the other ports.
îš„ Domain Name
When you use Active Directory of Windows 2000 Server, Windows Server
®
2003, Windows
Server 2008, or Windows Server 2012 as server, specify the domain name of Active Directory
in [Domain Name]. Up to 64 characters are allowed.
Important • Enter a realm name in uppercase characters. Otherwise, an authentication error occurs.
îš„ Server Certificate Verification
Select whether or not to verify a server certificate.
LDAP Server/Directory Service Settings (ApeosPort Series Models Only)
Configure the directory server, authentication method, and search attributes and ranges for
LDAP authentication and the Address Book search by LDAP.
îš„ Primary Server Name/Address
Enter the primary server name or IP address.
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to
255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
îš„ Primary Server - Port Number
Set the Primary server port number from 1 to 65535.
The default value is 389.
Important • Do not use the numbers assigned to the other ports.
îš„ Secondary Server Name/Address
Enter the secondary server name or IP address.
To Next Page
Loading...
Need help?
General
