15 Problem Solving
590
Problem Solving
15
Stapler Faults
This section describes how to clear stapler troubles when the optional finisher is installed.
Perform the procedures on the following pages when copies are not stapled or staples are
bent. Contact our Customer Support Center if the problem persists after you have tried the
following solutions.
Important • Even if the sheets have been stapled together properly, staples may rise up depending on the way
you handle the sheets.
If copies are stapled as shown in the figures below, contact our Customer Support Center.
Important • When using D2-Staple-Finisher or D2-Staple-Finisher with Booklet Maker, depending on the type of
paper that is being stapled, the stapled nails may be bent. If the bent nails are stuck inside the
machine, they may eventually cause paper jams.
One side of staple rising up Staple bent in reverse direction
Flattened staple Entire staple rising up
Staple rising up with center
pressed in
To Next Page
Loading...
