Fax Service Settings
223
Tools
5
Starting Rate
Set the default value for [Starting Rate] in the [Fax/Internet Fax Options] screen.
Delay Start - Specific Time
Set the default value for [Specific Time] of [Priority Send/Delay Start] in the [Fax/Internet
Fax Options] screen when [Specific Time] is selected for [Delay Start].
Transmission Header Text
Set the default value for [Transmission Header Text] in the [Fax/Internet Fax Options]
screen.
Confirmation Options
Set the default value for [Confirmation Options] of [Acknowledgement Report] in the [Fax/
Internet Fax Options] screen.
Note • You can select Delivery Receipts or Read Receipts in [Delivery Confirmation Method]. For more
information on the delivery confirmation method, refer to "Delivery Confirmation Method" (P.234).
Delivery Receipts/Read Receipts
Set the default value for [Read Receipts] or [Delivery Receipt] of [Acknowledgement Report]
in the [Fax/Internet Fax Options] screen.
Note • You can select Delivery Receipts or Read Receipts in [Delivery Confirmation Method]. For more
information on the delivery confirmation method, refer to "Delivery Confirmation Method" (P.234).
Internet Fax Profile
Set the default value for [Internet Fax Profile] in the [Fax/Internet Fax Options] screen.
Internet Fax Subject
Set the default value for [Internet Fax Subject] in the [Fax/Internet Fax Options] screen. Up
to 128 single-byte characters can be entered for the subject.
Internet Fax Encryption
Set the default value for [Encryption] in the [Fax/Internet Fax Options] screen.
Note • This feature appears only when the root certificate for a remote server for remote authentication
(except for ApeosWare Authentication Management) is set.
Fax Control
You can configure the settings related to fax control.
Re-enter Recipients
Set whether to re-enter the recipient after once specifying the recipient, to reduce the risk of
sending a fax, an IP fax, or an Internet fax to the wrong address. When Re-enter Recipients
is set to [Enter Twice], if you specify the recipient by entering the phone number, or by
selecting from the Address Book, the screen prompting you to re-enter the recipient appears.
If the same recipient has been entered, the transmission process will start.
Re-enter Broadcast Recipients
This setting is required when you selected [Enter Twice] for [Re-enter Recipients]. Set
whether or not to allow the Broadcast Send.
z
Enter Once Only
To Next Page
Loading...
