Changing the Paper Size
57
Paper and Other Media
2
5 Unscrew the screw of the front guide and
remove the guide from the tray.
6 Insert the small protrusions at the bottom of the guide into holes corresponding to the
paper size (1). Insert the screw into a hole corresponding to the paper size on the top of the
guide and tighten up the screw (2).
7 Pull the lever up of the end guide and move it
along the slot (1). Set the lever at the position
corresponding to the paper size (2) and press
the lever down (3).
Important • Adjust the end guide accordingly with the
size of paper. If the end guide is not adjusted
correctly, the machine cannot feed the paper
properly, resulting in a paper jam.
Note • The slot on the left of 8.5" is not used.
8 Open the end guide (1) and load and align the
edge of the paper against the right edge of the
tray with the side to be copied or printed on
facing up (2).
Important • Do not load paper above the maximum fill
line. It might cause paper jams or machine
malfunctions.
9 Close the end guide tightly.
10 Push the tray in gently until it stops.
To Next Page
Loading...
Need help?
General
