16 Appendix
664
Appendix
16
Extended Settings
Paper size 102 Sets the default paper size. Only available when [Paper tray] is set to [Auto] or
[Tray 5]. Only cut sheet can be set.
[3] : A3
[4] (Default) : A4
[5] : A5
[14] : B4
[15] : B5
[99] : Auto
[101] (Default) : A Size
Important • When Trays 1 to 4, Tray 6 to 7 is selected, [Paper size] cannot be set. The
paper size loaded in the specified tray is displayed.
Note • If [A Size] or [Auto] is selected, the settings become as follows:
- When [Document size] is set to other than [Auto], [Paper size] is set to
[A3].
- When Trays 1 to 4, Tray 6 to 7 is selected, the paper size is determined by
the size of paper loaded in the tray, and thus [Paper size] cannot be set.
- Depending on the combination of [Document size] and [Paper size], [?]
may be displayed for the magnification. In this case, the document is
printed at a scale of 100%.
Paper tray 103 Sets the paper tray to be used for printing.
[0] (Default) : Auto
[1] : Tray 1
[2] : Tray 2
[3] : Tray 3
[4] : Tray 4
[5] : Tray 5
[6] : Tray 6 (HCF (A4 1 Tray) or (A4 2 Tray)
[7] : Tray 7 (HCF (A4 2 Tray))
Important • When Trays 1 to 4, Tray 6 to 7 is selected, the paper size is determined by
the size of paper loaded in the tray, and thus [Paper size] cannot be set.
Also, the paper size of for Trays 3 to 4 is fixed at A4 size. To change the
paper size, contact our Customer Support Center.
Note • When [Auto] is selected and paper of the same size in the same orientation
in multiple trays is loaded, paper will be fed in the order of Tray 1 J Tray 2
J Tray 3 J Tray 4 J Tray 6 J Tray 7. If paper of the same size is loaded
in multiple trays but in different orientations, feeding of the paper loaded
in the landscape orientation is prioritized.
Coordinate
rotation
104 Sets the paper orientation for printing.
[0] (Default) : 0 degree
[1] : 90 degree
Parameter Item No. Value
Parameter Item No. Value
Auto layout 106 Selects whether to perform auto layout of the document or not.
[0] (Default) : ON
[1] : OFF
Active palette 107 Selects whether to use a pen specified by command or set on the panel.
[0] (Default) : Command
[1] : Panel
No. of prints 108 Sets the number of copy to be printed.
[1] - [250] (Default: 1) : 1 - 250
To Next Page
Loading...
Need help?
General
