Installation Procedures
395
Using IP Fax (SIP)
10
5) Select [ID], and then select [Change Settings].
6) Specify an ID, and then select [Save].
7) Select [Gateway Address], and then select [Change Settings].
8) Specify the IP address of the VoIP gateway, and then select [Save].
9) Select [Save].
10) To configure another VoIP gateway, repeat steps 4 to 9.
11) Select [Close].
3 Select [Close] repeatedly until the [Tools] screen is displayed.
4 Select [Close].
Note • Rebooting the machine may be required depending on the settings. When a message displayed on
the screen, follow the message and reboot the machine.
5 Print a configuration report to confirm the VoIP gateway settings.
For information on how to print a configuration report, refer to "Print Reports" (P.120).
To Next Page
Loading...