Fuji Xerox DocuCentre-V C4475

Fold Position Adjustment
661
Appendix
16
6 Select [Long at Left] or [Long at Right], and
enter the value you measured in the step 5 in
[Value A Before Adjustment].
7 Select [Adjust].
8 Select [Sample Printout] again.
9 Select the tray in which you loaded paper and press the <Start> button.
The sample is printed.
10 Select [Close].
11 Confirm the result of sample printout.
12 Adjust the alignment again if necessary. (Steps 5 to 11)
13 Select [Save].
14 Select [Close] until the Services Home screen is displayed.
Note • When you configure settings under [System Settings] or [Setup] and then press the <Services Home>
button, the screen directly goes back to the Services Home screen.
Booklet Position Adjustment
Adjust the booklet position.
1 Select [Booklet], and then select [Change
Settings].
2 Select [Sample Printout].
3 Select the tray in which you loaded paper,
select [2-Sheet Stack], and press the <Start>
button.
The sample is printed.