System Settings
143
Tools
8
The machine's power is not turned OFF completely in Low Power mode. Instead, this mode
creates a balance between low power consumption and short warm-up time by controlling
the temperature of the fusing unit to a level midway between the power OFF temperature
and the "Ready" temperature.
[1 minute] is set at the time of factory shipment.
Sleep Mode
Used to set the amount of time the machine waits before switching from Low Power mode
to Sleep mode.
You can set a value between 1 and 239 minutes (in 1 minute increments).
Sleep mode minimizes power consumption by shutting off the power to all components
except the controller. Warm-up time in Sleep mode is longer than in Low Power mode.
[1 minute] is set at the time of factory shipment.
Idle Timeout
The amount of time to wait is set according to the operations listed below when document
is placed on the document glass and being scanned.
The amount of time that passes to continue to the next job assuming that there is no
additional document to be loaded.
[30 seconds] is set at the time of factory shipment.
You can select [20 seconds], [30 seconds], [60 seconds], or [90 seconds].
Job Cancel Timer
Sets whether the machine automatically cancel the job when an error occurs.
You can select [On] or [Off]. If [On] is selected, you can set a value between 60 and 5940
seconds (in 1 second increments).
[600 seconds] is set at the time of factory shipment.
Clock
Sets the time on the machine's system clock. This item sets the clock used to print the
current time on the reports.
Note • When setting the time for the first time, first set the [Date Format] and [Time Format].
Follow the steps below to make the settings.
Date & Time
Set the current date and time.
1 In the [System Settings] screen, select [Region &
Timer Settings], and then press the <OK> button.
2 Select [Clock], and then press the <OK> button.
Consumables Settings
...
Region & Timer Settings
...
System Settings
Paper Tray Settings
...
Job Cancel Timer
...
600 seconds
Clock
...
Region & Timer Settings
Idle Timeout
...
30 seconds
To Next Page
Loading...
Need help?
General
