Home > Paper Handling > Load Paper > Load and Print Using the Multi‑purpose Tray (MP Tray) > Load
and Print Plain Paper, Letterhead, Coloured Paper, Thin Paper, Recycled Paper and Bond Paper in the MP
Tray
Load and Print Plain Paper, Letterhead, Coloured Paper, Thin Paper,
Recycled Paper and Bond Paper in the MP Tray
When you load a different size and type of paper in the tray, you must change the Paper Size and Paper Type
settings in the machine or on your computer, also.
1. Lift the support flap to prevent paper from sliding off the face down output tray.
2. Open the MP tray and lower it gently.
3. Pull out the MP tray support (1) and unfold the flap (2).
4. Slide the MP tray paper guides to fit the width of the paper you are using. If the paper guide on the right side
has a lever, press it and slide the paper guide.
5. Load paper with the printing surface face up in the MP tray. When you use Letterhead or Preprinted paper,
load the paper in the correct orientation as shown in the illustrations.
23
To Next Page
Loading...
Need help?
General
