Level 1 Level 2 Description
2-sided
When you use Letterhead or Preprinted paper, you must select the 2-
sided Feed option. If you select 1-sided Feed for Letterhead or
Preprinted paper, the last page will be printed on the reverse side.
Paper Type MP Tray
Select the paper type that matches the paper in the MP tray.
Tray1
Select the paper type that matches the paper in the standard paper tray.
Tray2
1
Select the paper type that matches the paper in the Tray Module (Optional)
(Tray 2).
Tray3
1
Select the paper type that matches the paper in the Tray Module (Optional)
(Tray 3).
Paper Size MP Tray
Select the size of paper you loaded in the MP tray.
Tray1
Select the size of paper you loaded in the standard paper tray.
Tray2
1
Select the size of paper you loaded in the Tray Module (Optional) (Tray 2).
Tray3
1
Select the size of paper you loaded in the Tray Module (Optional) (Tray 3).
Paper Low
Notice
Notification
Select whether to display a message telling you that the paper tray is nearly
empty.
Notice Level
Select the minimum paper level that will trigger the message.
Check Size
- Select whether to display a message telling you to check that the size of the
paper in the machine and the machine's Paper Size setting match.
1
Available if the Tray Module(s) (Optional) is installed.
[General Setup]
Level 1
Level 2 Description
Local Language
- Select the LCD language for your country.
Resolution
- Choose a print resolution.
Density
- Increase or decrease the print density.
Ecology Toner Save
Increase the page yield of the toner cartridge.
Sleep Time
Set how much time will pass before the machine enters Power Saving
Mode.
Quiet Mode
Decrease printing noise.
Auto Power Off
Set the number of hours that the machine will remain in Deep Sleep Mode
before going into Power Off Mode.
Panel Control Button Repeat
Set the time for the LCD message to change when holding a or b at
intervals.
Message Scroll
Set the time in seconds that an LCD message will scroll across the LCD.
From Level 1=0.2 sec to Level 10=2.0 sec.
LCD Contrast
Adjust the contrast of the LCD.
Auto Online
Set the machine to return to Ready Mode after it has been idle for 30
seconds.
Setting Lock
- Lock your machine’s settings using the Setting Lock password.
Interface Select
Select the interface to use.
If you select Auto, the machine changes the interface to USB or Network
depending on which interface is receiving data.
Auto IF Time
Set the time-out period for the auto interface selection.
Input Buffer
Increase or decrease the input buffer capacity.
Fixed Port
Enable or disable the Fixed Port function.
276
To Next Page
Loading...
Need help?
General
