FujiFilm DS-7 - Notes on Using Memory Cards; Storing Data

Notes on Using Memory Cards
@ Storing Data
¢ In the situations listed below, recorded data may be erased (destroyed).
Please note that FUJIFILM accepts no responsibility whatsoever for the
loss (destruction) of recorded data.
When the card is used incorrectly by the owner or a third party.
* When the card is exposed to static electricity or electrical noise.
* When the card cover is opened or the card is removed and the camera
switched off during data recording, during data erasing (card
initialization) or during frame advance when images are being played
back.
© Back up important data onto another medium (MO disk, floppy disk, hard
disk, etc.).
@ Notes on Handling Memory Cards
* Never open the card cover or remove the card, thereby switching the
camera off, during data recording, during data erasing (card initialization) or
during frame advance when images are being played back. These actions
could result in damage to the card.
* Use only the card specified for use with the DS-7. The use of other cards
could damage the camera.
* Memory cards are precision electronic devices. Do not bend, drop, or
subject cards to excessive shocks.
* Do not use or store memory cards in environments likely to be affected by
strong static electricity or electrical noise.
* Do not use or store memory cards in very hot, humid or corrosive
environments.
Take care not to touch the card's contact surfaces or allow the surfaces to
become soiled. Use a dry lint-free cloth to wipe away any soiling that does
occur.
* To avoid exposing the card to static electricity when you carry or store it,
always keep the card in the special static-free case provided. Use a storage
case if available.
* Do not carry memory cards in locations such as a trouser pocket. This
could subject the card to excessive force when you sit down, thereby
damaging the card.
* Acard may feel warm when it is removed from the camera after extended
periods in recording or playback mode. This is not a fault.