FujiFilm Instax Square SQ 6 User Manual (English)

Other manuals for FujiFilm Instax Square SQ 6

Questions and Answers:

M
Maurice BaldwinAug 19, 2025
Why is my FujiFilm Instax Square SQ 6 Digital Camera picture out of focus?
- J
  John StewartAug 19, 2025
  If your FujiFilm Digital Camera pictures are out of focus, consider these possibilities: 1. The shooting distance might not be appropriate. Select the shooting mode according to the distance. 2. The lens may be dirty. Clean the lens. 3. The camera may have been shaken during the shot. Hold your camera firmly and gently press the shutter release button. When shooting indoors or in dark conditions, stabilize the camera using a table or tripod.
J
Jo HenryAug 21, 2025
What to do if FujiFilm Instax Square SQ 6 Digital Camera lens does not work?
- D
  debra29Aug 21, 2025
  If the lens on your FujiFilm Digital Camera does not work when the power is switched on, replace both CR2 batteries with new lithium batteries of the same brand/type.
L
Lisa BryantAug 23, 2025
Why does my FujiFilm Instax Square SQ 6 Digital Camera battery drain so fast?
- W
  whitewilliamAug 23, 2025
  If your FujiFilm Digital Camera battery is draining quickly, it might be because the batteries are not the same type. To resolve this, replace both batteries with new CR2 lithium batteries of the same brand and type.
J
Jenny HillAug 26, 2025
What to do if my FujiFilm Digital Camera shutter release won’t trip?
- A
  Angela HoldenAug 26, 2025
  If the shutter release on your FujiFilm Digital Camera won’t trip, here are a few possible reasons and solutions: 1. The battery power may be low. Replace both batteries with new ones. 2. The LED on the flash suppressing button or the self timer lamp might be flashing rapidly, indicating that the flash is charging. Wait until the LED or lamp turns off. 3. The film counter may be showing a “0” sign. In this case, unload the film pack and load a new one.
H
hannah44Aug 28, 2025
What to do if my FujiFilm Instax Square SQ 6 Digital Camera film cannot be ejected?
- J
  Jordan MartinAug 28, 2025
  If the film cannot be ejected from your FujiFilm Digital Camera: 1. It could be that the camera shook or was dropped, causing the film to misalign. Try loading a new film pack. 2. The film may have jammed. Remove both batteries and insert them again. If this doesn’t work, carefully remove the jammed film and then load a new film pack.
D
Dennis ChavezAug 30, 2025
What to do if my FujiFilm Instax Square SQ 6 Digital Camera film pack won’t load?
- J
  Joseph PerezAug 30, 2025
  If the film pack won’t load into your FujiFilm Digital Camera, consider the following: 1. Ensure that you are using the correct film pack. Use only FUJIFILM Instant Film “instax SQUARE”. Other films are not compatible. 2. Make sure you are loading the film pack correctly. Match the yellow line on the film pack with the yellow positioning mark in your camera, following the FUJIFILM Instant Film “instax SQUARE” instructions.
J
Jamie WhiteSep 1, 2025
What to do if my FujiFilm Instax Square SQ 6 Digital Camera finished print is all white?
- L
  Lisa GarrisonSep 1, 2025
  If your FujiFilm Digital Camera produces a finished print that is partly or entirely white, it could be because the back cover was opened before all the film was used. Avoid opening the back cover until you have used up the entire film pack to prevent exposing and ruining the remaining film.
D
daniel19Sep 3, 2025
What to do if my FujiFilm Digital Camera film cover cannot be ejected?
- J
  James HowardSep 3, 2025
  If the film cover cannot be ejected from your FujiFilm Digital Camera, the battery power may be low. Try replacing both batteries with new ones and then load the film pack again.
P
Pamela FisherSep 5, 2025
Why is my FujiFilm Digital Camera print overexposed?
- P
  Pamela LopezSep 5, 2025
  If your FujiFilm Digital Camera finished print looks overexposed (white in color), it could be due to: 1. Low ambient temperature (below +5°C). Place your camera in a warm place to bring it to room temperature before taking pictures. 2. The AE light sensor window or flash sensor window was covered. Be careful not to block these sensors.
K
Kristen MyersSep 7, 2025
What to do if my FujiFilm Instax Square SQ 6 Digital Camera LED(s) on the mode indicator is flashing?
- J
  julia44Sep 7, 2025
  If the LED(s) on the mode indicator of your FujiFilm Digital Camera is flashing, the camera may have a problem. Remove the batteries and reinsert them while the LED is flashing. If this does not resolve the problem, contact a FUJIFILM authorized distributor.

FujiFilm Instax Square SQ 6 Specifications

General

Camera Type	Instant Film Camera
Film Format	Instax Square
Film	Instax Square Film
Image Size	62mm x 62mm
Film Feeding Out	Automatic
Flash	Built-in Flash
Selfie Mode	Yes
Dimensions	118.7 mm x 128.1 mm x 58.1 mm
Lens	65.75 mm f/12.6
Viewfinder	Real Image Viewfinder
Shooting Range	0.3 m to ∞
Shutter Speed	1/2 to 1/400 sec
Exposure Control	Automatic
Flash Range	0.3m - 2.7m
Self-Timer	Yes
Display	LCD
Power Supply	2 x CR2 lithium batteries
Weight	393 g (without batteries, strap, and film)