1
Sonosite PX System Battery Assembly Instructions
Inside the box
Installing the system battery
System batteries (2)
Battery compartment cover (1)
M3 x 8 mm Phillips-
head screws (6)
STEP 1 STEP 2
Access the system’s battery compartment.
Place one of the batteries in the compartment as
shown, then plug its cable into the connector. Make
sure the cable is placed fully within the compartment.
STEP 3
Place the other battery in the compartment as
shown, then plug its cable into the connector.
Make sure the cable is placed fully within the
compartment.
STEP 4
Attach the battery compartment cover using a
Phillips screwdriver and the Phillips-head screws.*
*A magnetic bit driver and Phillips #1 bit are
available in the stand assembly kit.
To Next Page
Need help?
General
