Fujitsu 2737 - Page 161

4 Handling the Rack after Installation 161
E
2 Draw out the table about 185 mm (until the screw holes for securing rear
brackets L and R are visible).
Some strength is needed to draw out the table because the simple retainer mechanism of the
slide rails is engaged.
3 Secure rear bracket L to front bracket L, and secure rear bracket R to front
bracket R. Secure them by applying M6 screws to the second lower screw
hole from the rear and the second upper screw hole from the rear. (See
Section G-G.)
 Secure the table in position while fully pressing rear brackets L and R against the
rack posts (in the direction of arrow A).
 Secure the table in position while fully pressing rear bracket L against front
bracket L and rear bracket R to front bracket R so that no gaps appear (in the
directions of arrows B and C).
 If you are unable to press against rear brackets L and R adequately, do so after
slightly loosening the M6 screws marked with an asterisk (*).
 The table can be drawn out about 152 mm (until the screw holes for securing rear
brackets L and R are visible). Do not draw it out too much (see section G-G).
4 Put away the table that was drawn out in step 2 and engage the simple
retainer mechanism of the slide rails.
Pull-out length of about 152 mm
for table
* Same locations as in rear bracket L
Cross section G-G
Screw holes in rear bracket R used for
fixing it in position
Table
Second screw hole
from rear in bottom row
Second screw hole from rear in top row
Front bracket R
Rear face is here
when table is put away
#
$
%
#
%
)
Table
Rack post
$
Rear bracket L
)
Rear bracket R
Front bracket R
Table
M6 screws
#
$
%
M6 screws
Rear bracket R
Front bracket R
Front bracket L
Rear bracket R