01-18
19. ENERGY SAVE FUNCTION
(Using the Wired Remote Controller)
1. During Cooling / Dry operation:
The thermostat temperature setting increases by 1.8 degF (1 degC) as soon as the ENERGY SAVE button is pressed,
and then increases by 1.8 degF (1 degC) after 1 hour later.
Afterwards, energy consumption is saved by continuing to cool or dry at a thermostat temperature of 3.6 degF (2 degC)
higher than setting temperature.
2. During Heating operation:
The thermostat temperature setting decreases by 1.8 degF (1 degC) as soon as the ENERGY SAVE button is pressed,
and then decreases by another 1.8 degF (1 degC) every 30 minutes.
Afterwards, energy consumption is saved by continuing to heat at a thermostat temperature of 7.2 degF (4 degC)
lower than setting temperature.
1hour.
1.8 degF
(1 degC)
3.6 degF (2 degC)
ENERGY
SAVE ON
Setting
temperature
1.8degF
(1degC)
3.6degF
(2degC)
5.4degF
(3degC)
7.2degF
(4degC)
30min.
1 hour.
1 hour
30 min.
ENERGY
SAVE ON
Setting
temperature
18. MANUAL AUTO OPERATION
(Using the Wireless Remote Controller)
If MANUAL AUTO Button is set, the operation is controlled as shown in Table 11.
If the remote control is lost or battery power dissipated, this function will work without the remote control.
OPERATION MODE
Auto changeover
FAN CONT. MODE
Auto
TIMER MODE
Continuous (No timer setting available)
SETTING TEMP.
73.4°F (23°C)
SETTING LOUVER
Standard
SWING
OFF
(Table 11 : Manual auto operation )