Fujitsu AGYG14LVCB - SWING OPERATION; MANUAL AUTO OPERATION

En-14
SWING OPERATION
MANUAL AUTO OPERATION
Use the MANUAL AUTO operation in the event the Remote Controller is lost or otherwise unavailable.
How To Use the Main Unit Controls
Press the MANUAL AUTO button (Fig. 2
3
) more than 3 sec-
onds and less than 10 seconds on the main unit control panel.
To stop operation, press the MANUAL AUTO button (Fig. 2
3
) for 3 seconds.
●
When the air conditioner is operated with
the controls on the Main Unit, it will oper-
ate under the same mode as the AUTO
mode selected on the
Remote Control-
ler
(See page 7.).
●
The fan speed selected will be “AUTO”
and the thermostat setting will be stan-
dard. (24
°C
)
Begin air conditioner operation before performing this procedure.
To select SWING Operation
Press the SWING button (Fig. 5
R
).
The SWING Display (Fig. 6
]
) will light.
In this mode, the Airfl ow Direction Louvers will swing automatically to direct the airfl ow
both up and down.
To stop SWING Operation
Press the SWING button (Fig. 5
R
) once again.
The SWING Display (Fig. 6
]
) will go out.
Airfl ow direction will return to the setting before swing was begun.
About Swing Operation
Swings between
1
and
5
.
●
The SWING operation may stop temporarily when the air conditioner’s fan is not operat-
ing, or when operating at very low speeds.
9378532045_OM.indb 149378532045_OM.indb 14 9/28/2011 4:21:44 PM9/28/2011 4:21:44 PM