EasyManuals Logo

Fujitsu AGYG14LVCB User Manual

Fujitsu AGYG14LVCB
112 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
En-6
PREPARATION
CAUTION
Take care to prevent infants from acciden-
tally swallowing batteries.
When not using the Remote Controller for
an extended period, remove the batteries to
avoid possible leakage and damage to the
unit.
If leaking battery uid comes in contact
with your skin, eyes, or mouth, immediately
wash with copious amounts of water, and
consult your physician.
Dead batteries should be removed imme-
diately and disposed of properly, either in a
battery collection receptacle or to the appro-
priate authority.
Do not attem pt to recharge dry batteries.
Never mix new and used batteries, or
batteries of different types.
Batteries should last about 1 year under
normal use. If the Remote Controller’s
operating range becomes appreciably
reduced, replace the batteries and press
the RESET button with the tip of a ball-
point pen or other small object.
3
To remove the Remote Con-
troller (when use at hand).
1
Mount the Holder.
2
Set the Remote Controller.
Screws
Insert
Press in
Slide up
Pull out
Load Batteries (R03/LR03
×
2)
1
Press and slide the battery compartment lid on the re-
verse side to open it.
Slide in the direction of the arrow while pressing the mark.
2
Insert batteries.
Be sure to align the battery polarities ( ) correctly.
3
Close the battery compartment lid.
Set the Current time
1
Press the CLOCK ADJUST button (Fig. 5
T
).
Use the tip of a ball-point pen or other small object to press the button.
2
Use the TIMER SET (
/ ) buttons (Fig. 5
S
) to
adjust the clock to the current time.
button: Press to advance the time.
button: Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed in
1 minute increments; hold the buttons depressed to change the time quickly
in 10 minute increments.)
3
Press the CLOCK ADJUST button (Fig. 5
T
) again.
This completes the time setting and starts the clock.
To Use the Remote Controller
The Remote Controller must be pointed at signal receiver (Fig. 1
5
) to operate cor-
rectly.
Operating Range: About 7 meters.
When a signal is properly received by the air conditioner, a beeping sound will be
heard.
If no beep is heard, press the Remote Controller button again.
Remote Controller Holder
9378532045_OM.indb 69378532045_OM.indb 6 9/28/2011 4:21:42 PM9/28/2011 4:21:42 PM

Table of Contents

Other manuals for Fujitsu AGYG14LVCB

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu AGYG14LVCB and is the answer not in the manual?

Fujitsu AGYG14LVCB Specifications

General IconGeneral
BrandFujitsu
ModelAGYG14LVCB
CategoryAir Conditioner
LanguageEnglish

Related product manuals